Dashcams: A Small Camera That Watches the Road
A dashcam is a small camera that sticks to the windshield and records the road ahead while you drive. It asks nothing of you day to day — it starts with the car and records on its own — and it is there for the one day you need proof of what actually happened. This lesson covers the kinds, the memory card that makes it work, how the recording loop protects the important minutes, parked recording, and how to watch a video afterward. Fitting and setup are parked jobs, every one.
Words to know first
- Loop recording: the camera records in short pieces and, when the card fills, erases the oldest unsaved pieces to make room. The card never fills up and stops.
- Memory card (microSD): the tiny card inside the camera where the video lives. Without one, the camera records nothing.
- Incident: a bump or jolt the camera's sensor notices. The camera saves the video around it into a protected set the loop cannot erase.
- Parking mode: while the car is off and parked, the camera sleeps until a bump or movement wakes it to record a short clip. It needs a special power cable — see below.
- Hardwiring: connecting the camera straight into the car's electrical system instead of plugging it into the round socket.
The kinds you will see
- Front only. One camera, the road ahead. The standard choice, and the simplest to fit.
- Front and rear. Adds a second, smaller camera on the rear window, joined to the front one by a long cable that runs the length of the cabin. Running that cable neatly is the fiddly part — many people have a shop do just that bit.
- Front and cabin. The second lens looks into the car instead of behind it — Garmin's Tandem is one. It is the choice of people who carry passengers for work.
- Screens vary. Some cameras have a small screen on the back; some have none at all and show everything in the phone app instead. Neither is better — it is about whether you like a screen.
Where it sits, and where it plugs in
- High on the windshield, behind or beside the rear-view mirror — where it sees the whole road and stays out of your own view of it. A sticky pad or a suction cup holds it; both come in the box.
- Power is a cable to the round 12-volt socket — the one older cars called the cigarette lighter. Tuck the cable along the edge of the windshield and down the side, so it never dangles near your hands, the wheel, or the pedals.
- With socket power, the camera starts when the car starts and stops when it stops — exactly what most people want. One caution: on a few cars that socket stays live even when parked, so the camera keeps sipping power. If your car is one of those, unplug the camera on long parks — or read the parking section below before deciding.
The memory card — the part people get wrong
- The card is not always in the box. Buy a microSD card made for dash cams — the package will say "high endurance." A camera rewrites its card all day, every day, and ordinary cards wear out fast under that work. Garmin's own support pages say it directly: choose a card specifically designed for dash cams.
- Speed: look for "Class 10" or faster on the package. Garmin requires Class 10 or higher for its cameras, and other makers ask the same.
- Size: a bigger card holds more driving before the loop starts reusing space. Garmin's example for its own cameras, at the usual picture quality: a 16 GB card holds about 2 hours of driving; a 256 GB card holds about 34 hours.
- Format the card in the camera. Put the card in, then use the camera's own Format choice in its settings (on Garmin cameras it lives at Settings → Camera → Format Card). Formatting erases the card completely — that is expected — and sets it up the way the camera wants. Do it again every few months; Garmin suggests at least every 6 months. Cards wear out, and the camera will tell you when it starts spotting card errors.
How the loop protects the minutes that matter
- The camera records in short pieces, one after another. When the card fills, the oldest unsaved pieces are erased to make room for new ones. So the card always holds your most recent hours of driving, and it never needs emptying by hand.
- A jolt makes the camera protect the moment. A collision — even a hard pothole — tells the sensor to save the pieces from just before, during, and just after the event into a protected set the loop cannot erase.
- You can save a moment yourself. Most cameras have a button (some also take a voice command) that protects the piece being recorded. Learn where yours is while parked, before the day you want it.
- The honest catch: protection only helps while the clip is still on the card. After any incident, copy the video to your phone or computer the same day — the next section shows how — rather than trusting the card to keep it forever.
Parked recording — and the shop job
- Many cameras offer parking mode: parked and off, the camera sleeps until a bump or nearby movement wakes it to record a short clip — the parking-lot tap-and-run is what it exists for.
- It cannot run on ordinary socket power, because most sockets die with the ignition. Parking mode needs constant power: either a special cable wired into the car's electrics, or an adapter that plugs into the car's diagnostic socket (the OBD socket, under the dash). Garmin sells both kinds — and prints this caution in its own manual: it strongly recommends an experienced installer do the wiring, because wiring it wrong can damage the car or its battery.
- Our version of the same advice: plugging into the round socket is a do-it-yourself job; anything that touches the car's wiring is a shop job. If you want parking mode, budget for the fitting when you price the camera.
Watching a video afterward
- In the maker's app: most cameras make their own Wi-Fi network for your phone. Parked, join it from the phone's Wi-Fi settings, open the maker's app (Garmin's is called Garmin Drive), and view the clip or save it to the phone.
- Or by the card: turn the camera off, pop the card out, and put it in a computer with a card reader. The videos are ordinary files, kept in folders.
- Save the keeper twice — phone and computer, or send it to a family member. A clip that exists in one place is a clip halfway to being lost.
One honest legal line
Garmin prints a notice in its manuals, and it is all the law you need from us: some places regulate or even prohibit these devices, and it is your responsibility to know and follow the rules where you drive. Rules about recording — especially recording sound inside the car — vary from state to state. Check your state's; and know that most cameras let you turn the microphone off in their settings if yours calls for it.
Fix common problems
- "It says no card, or card error." The card is missing, worn out, or too slow. Push it in again until it clicks; format it in the camera; if errors come back, replace it with a fresh high-endurance Class 10 card. Cards are consumables — they are meant to be replaced.
- "It stops recording." Usually the card again — this time, full of protected clips. Copy off anything you need, then format the card in the camera.
- "The picture is hazy at the edges." Peel the protective film off the lens — cameras ship with one — and clean the inside of the windshield. The haze is usually on the car's glass, not the camera's.
- "It fell off the windshield." Heat loosens suction cups. Clean the glass, press the mount back on firmly, or switch to the sticky-pad mount that came in the box.
For the rest of the car layer — mounts, charging, and the phone's own driving modes — see The Phone in the Car: Mounts, Voice, and the Honest Rules, and the side-by-side in our chart Your Phone in the Car at a Glance.
Words in this lesson
- Consumable: a part that is expected to wear out and be replaced — like brake pads, or a dashcam's memory card.
- OBD socket: the car's diagnostic port, usually under the dashboard on the driver's side. Mechanics plug test equipment into it; some camera power adapters use it too.
- Format: to erase a card completely and set it up fresh, in the exact pattern a device expects. The camera's own Format choice always beats a computer's guess.