387.My watch keeps asking for a passcode. How do I stop it?
First, what is supposed to happen: the watch asks for its code when it thinks it has been off your wrist — that is the lock doing its job. You put the watch on in the morning, type the code once, and it should stay unlocked until you take it off at night. If it is asking again and again while you are wearing it, the watch is losing track of your wrist. That is what these steps fix. (Apple Watch and Samsung Galaxy Watch are the two this page covers; the idea is the same on both.)
- Wear it a touch snugger, and a little higher. This is the most common cause of all. The sensors on the back of the watch need steady contact with your skin to know it is still on you. A band worn loose, sliding up and down your arm, reads as “taken off” every time it shifts. Move the watch a finger-width above your wrist bone and tighten the band one hole — snug, not tight.
- Clean the back of the watch. Wipe the sensor side with a soft, dry cloth. A film of lotion, sunscreen, or sweat over the sensors fools them the same way a loose band does.
- Check the wrist-detection setting. On an Apple Watch: on your iPhone, open the Watch app → Passcode → make sure Wrist Detection is on. While you are there, turn on Unlock with iPhone — then unlocking your phone in the morning unlocks the watch too, as long as it is on your wrist. On a Galaxy Watch: open Settings on the watch → Security and privacy, and check the lock is set to ask only when the watch has been off your wrist (you can also find it in the Galaxy Wearable app on the phone → Watch settings).
- Mind sleeves and tattoos — the honest exceptions. A thick sleeve bunched up under the watch can lift it off your skin, and dark tattoo ink under the sensors can fool them too. If the asking happens mostly with one coat or one sleeve, you have found it — pull the sleeve back past the watch.
- Restart both the watch and the phone. If the asking started suddenly this week, especially right after an update, a restart of each settles the sensors and the connection between them.
If you have truly forgotten the code: nobody can unlock the watch for you — not Apple, not Samsung, not Sean — and never pay a website or caller who offers to unlock it; that is a scam. The honest fix is to wipe the watch and set it up fresh (Apple Watch: Watch app → General → Reset; Galaxy Watch: Settings → General → Reset). Your phone keeps a backup of the watch, so it comes back almost exactly as it was. Sean can do the wipe and restore with you, so nothing is lost and no step is guessed.