← All questions

Smart Home Gadgets

My garage door app says the door is open when it is closed. What should I check?

515.My garage door app says the door is open when it is closed. What should I check?

You looked with your own eyes: the garage door is shut. But the app on your phone insists it is open — or the other way round, which is worse. Believe your eyes, not the app. The door itself is almost never confused; the little battery sensor that rides on the door and reports its position is. Our Smart Home lesson about the garage door explains how that sensor works when a kit is set up; this page is for the day its report stops matching the door. The names differ — Chamberlain’s myQ, Genie’s Aladdin Connect, Tailwind, Meross — but every kit reads the door the same way, and the fixes below are in the order they actually happen.

  1. First, settle which direction the lie runs. If the app says closed but the door is standing open, close it now with the wall button and treat the rest of this page as today’s job — a door the app cannot see open is a door left open all night. If the app says open but the door is shut, nothing is unsafe; you are fixing a report, not a door, and you can work calmly.
  2. The sensor’s battery is dying — the number-one cause. The sensor is a small battery box stuck or screwed to the inside of the door itself. When its battery fades, it stops reporting, and the app keeps showing the last thing it heard — or guesses. Many apps bury a low-battery warning in the device’s page, so open the app, tap the door or sensor, and look. The battery is a flat coin-shaped cell (myQ sensors use a CR2450); it twists or slides out, the new one goes in the same way up, and a fresh battery fixes more false reports than everything else on this page combined.
  3. The sensor got knocked or has worked loose. It must sit flat and firm on the door, in the spot it was fitted — a sensor dangling by one corner reads the door’s tilt wrong. Press it back onto its mount, tighten or re-stick it, and make sure nothing stored against the door can bump it as the door moves.
  4. The door moved while nobody was reporting. If the power was out, or someone pulled the red release cord and moved the door by hand, the kit missed the trip and its count is stale. Cure it with one honest journey: using the wall button or the app, open the door all the way, let it stop, then close it all the way. Most kits re-learn the truth from one full trip; check the app after it lands.
  5. The report is stuck, not wrong. Close the app completely and open it again, and look at the time on the last report if your app shows one (myQ’s history list is good for this). A status that is hours old is a connection problem, not a door problem: the garage is the far corner of most houses, and the kit’s box needs Wi-Fi it can actually reach out there. If the app often shows stale times, the Wi-Fi-in-the-garage check in our garage lesson is the fix, not another sensor.
  6. Still lying with a fresh battery, a firm seat, and one full trip? Remove the sensor in the app and add it back (each app keeps this under the door’s or sensor’s settings; the kit’s own pairing steps from our garage lesson are the road). Re-adding is the kit’s factory-fresh start, and it settles the rare sensor that has simply forgotten itself.
In order: trust your eyes first (and close a truly-open door now) → fresh sensor battery → sensor pressed firmly back in its place → one full open-and-close trip to re-teach the kit → a status hours old means Wi-Fi, not the door. The app reports what the sensor last said; when the report and the door disagree, the sensor is where the truth went missing.