523.My power bank will not charge my phone. What should I check?
A power bank — the pocket battery you charge at home and carry with you — is the thing that is supposed to rescue a dying phone at the doctor’s office or in a power cut. So the day it sits there doing nothing is doubly annoying. The good news: most “dead” power banks are empty, asleep, or plugged in through the wrong hole — and each of those takes under a minute to prove. Our travel chart sings the power bank’s praises and our glossary defines it; this page is the day it will not work.
- Is the bank itself empty? Almost every bank has a button. Press it and read the little lights: four lights is full, one light is nearly empty, no lights at all usually means the bank is flat — a bank that was charged in the spring and carried all summer can be empty by autumn without ever being used. Charge the bank itself first, from a wall plug, for a few hours, and test again with the lights showing something.
- Wake it up. Many banks sleep between jobs and need that same button pressed after the phone is plugged in to start sending power. Plug the phone in, press the button once, and give it ten slow seconds — the phone’s charging picture or percentage is the judge, not the bank’s lights.
- Use the right hole. Banks have doors in and doors out. The socket you charge the bank through does not always send power back out — on many banks one socket is in-only. If your bank has two sockets, try the other one for the phone. (Newer banks with a single USB-C socket usually work both ways; two-socket banks are where this trap lives.)
- Suspect the cable before the bank. Swap in the cable you charge the phone with at home — the short cable that came in the bank’s box is the flimsiest thing in the bag, and its failure looks exactly like a dead bank. Built-in cables count double: if the bank’s own attached cable is the only road that fails, the bank is fine and the cable is not.
- Split the problem with a second device. Plug in another phone, a tablet, anything chargeable. If the second device charges, bank and cable are innocent and the first phone is the puzzle — its socket may be full of pocket fluff (our Power tip about a phone that will not charge walks that clean-out safely). If nothing charges, the fault is the bank’s side of the wire.
- Magnetic banks have one extra fit. A snap-on bank for an iPhone must sit centered on the phone’s back; a thick case, a card wallet case, or a half-inch of “nearly on” can leave it warm and charging nothing. Try it once with the case off and the bank seated squarely before blaming either.
- The honest ending. A bank that shows lights, is awake, feeds nothing through a known-good cable in either socket, and fails a second device too, has given out — pocket batteries wear out in a few years of service. And one safety rule outranks all testing: a bank that is swollen, bulging, very hot, or smells sweet or chemical is retired on the spot — do not charge it again (our lesson about the swollen battery explains why, and a store’s battery-recycling bin is where it goes).
In order: press the button and read the lights (no lights = charge the bank itself) → plug in, then press the button to wake it → try the other socket → swap the cable → prove it with a second device. Empty, asleep, wrong hole, bad cable — in that order — are nearly every “dead” power bank ever brought to the counter.