535.My phone won’t charge on the wireless charging pad. What should I check?
Your phone charges happily on its cable, but on the flat pad it does nothing — or it starts, stops, starts again. A pad is pickier than a plug: the phone has to sit in exactly the right spot, nothing much can stand between the two, and the pad itself needs a proper meal of power before it can feed your phone. Our charging question 372 covers a phone that will not charge at all and uses the pad as a test; this page is for when the pad is the problem. Work through these in order — the first two fix most pads.
- Find the sweet spot. Inside the back of the phone is a ring-shaped coil, and the pad has one too — charging only happens when the two rings line up. Lay the phone dead center on the pad, wait a full five seconds, and if nothing starts, nudge it a finger’s width up, down, left, right, pausing each time. On most phones the coil sits in the middle of the back; on some it sits a little high. If your pad and phone are magnetic (Apple calls it MagSafe), the snap tells you when you are home — no snap, no alignment.
- Take the case into the reckoning. Thick cases, wallet cases with cards in them, little grip rings and stick-on sockets, and metal plates (the kind that stick to a car’s magnetic holder) all block or bend the charge. Test one charge with the case off. If it charges bare, the case is your answer — a thinner case, or one sold as “wireless-charging friendly” (or MagSafe, for iPhones), is the fix.
- Feed the pad properly. Many pads are sold without a wall plug, and a pad fed by a weak old plug — or plugged into a computer or a power strip’s feeble USB hole — may light up and still give the phone almost nothing. Use a strong wall plug (the one that came with your phone is ideal), plugged straight into the wall, with the pad’s own cable pushed in all the way.
- A blinking light, or a charge that stops mid-way, usually means something is in the way — or heat. Pads watch for strangers: a coin, a key, or a credit card slipped between phone and pad makes the pad blink and refuse, on purpose, so the metal does not cook. Clear the pad’s surface. Heat does the same job from the other side: pad charging warms a phone more than a cable does, and a hot phone (heavy case, sunny windowsill, charging right after a long video call) pauses its own charging to protect the battery. Let it cool down, move the pad out of the sun, and try again.
- Check that your phone can do this at all. Not every phone has wireless charging — many lower-cost models and older phones simply do not, and no pad will ever wake them. If your phone has never charged on any pad, that may be the whole story; check the model’s name against its maker’s page, or ask Sean. And whatever the phone, one restart is worth it before you blame hardware — a stuck phone sometimes forgets how to charge until it has slept and woken.
- Decide which side is guilty before you buy anything. Put a friend’s or family member’s phone on your pad. If theirs charges, your pad and plug are fine and the question lives in your phone or its case. If theirs does not, swap in a known-strong plug and cable for the pad once more — and if the pad still does nothing for anybody, the pad itself has failed, which happens, and a replacement pad (not a replacement phone) is the spend.
- Two honest limits. A pad is slower than a cable — that is normal, not a fault, and overnight is what pads are for. And if your phone charges by cable but on no pad even bare and centered, the coil inside the phone can fail on its own; that is a repair-shop check, not a reason to buy pad after pad.
In order: center the phone on the pad and nudge for the sweet spot → test once with the case off (cards, grips, and metal plates block the charge) → feed the pad with a strong wall plug, not a computer → clear coins and cards off the pad and let a hot phone cool → confirm your phone has wireless charging at all, and test the pad with someone else’s phone before spending a penny.