← All questions

Sound

How do I clean my earbuds safely?

564.How do I clean my earbuds safely?

When earbuds go quiet, or muffled, or loud in one ear and shy in the other, the cause is usually not broken electronics — it is earwax and pocket dust, slowly covering the tiny speaker mesh. Cleaning is free, takes five minutes, and fixes most of it. The whole art is gentleness: that mesh tears, and earbuds hate water. Gather three things: a dry soft cloth, a soft-bristled brush (a clean, soft toothbrush kept just for this is perfect), and dry cotton swabs. This page covers AirPods and Galaxy Buds; other earbuds clean the same way.

  1. Brush the mesh — facing down. Hold the bud with its speaker mesh pointing at the floor and brush gently across the mesh with the soft brush, never jabbing into it. Facing down matters: loosened wax falls away from the bud instead of packing deeper in. A few light taps, mesh down against your palm, shake loose what the brush freed. Do the second bud, and the little mesh on the outside too, if yours has one.
  2. Wipe the outside — dry, or nearly. Polish the buds with the dry soft cloth. For sticky grime on the outside plastic only, the makers allow a cloth very slightly dampened with plain water — wrung out until it feels almost dry. Keep every drop away from the mesh openings and the charging contacts at the bud’s foot: inside is where water does its damage.
  3. Removable ear tips may be washed — the buds may not. If your buds wear soft silicone tips (AirPods Pro, Galaxy Buds, Pixel Buds and many others), pull the tips off and rinse the tips alone under plain water — no soap. Then let them dry completely, an hour or more, before pressing them back on. The buds themselves never go under a tap, not even the ones advertised as water-resistant: that rating is about rain and sweat, not a bath.
  4. Never do these. No pins, needles, toothpicks, or anything sharp into the mesh — sharp pushes wax deeper and can puncture the speaker. No sprays, no rubbing alcohol, no hand sanitiser on the buds. No hard blowing into them — your breath carries moisture. If the brush and patience have not shifted it, more force is not the answer; that is the honest edge of home cleaning.
  5. Clean the case while you are at it. Run a dry cotton swab around the inside of each well and across the small metal contacts at the bottom — dirty contacts are also why a bud quietly stops charging, which this shelf’s question about a case that won’t charge covers. Wipe the case’s outside with the cloth, and if anything got even slightly damp, leave the case standing open to dry before you close it.
  6. Still muffled after cleaning? Then the wax was not (or not all of) the story. If one side is still quieter, this shelf’s question about one ear hearing better walks the balance setting that evens the two sides out, and its question about earbuds that are too quiet at full volume covers the volume-limit switches that can hold a bud down. A bud that stays muffled after cleaning and those checks may simply be failing — that is a call Sean moment, and a single replacement bud is usually buyable on its own.
In short: brush the speaker mesh gently with the bud held facing down, so the wax falls out instead of packing in → wipe the outside with a dry soft cloth (a nearly-dry damp cloth is allowed on the outside plastic only) → soft silicone tips may come off and be rinsed in plain water, then dried fully before going back → never anything sharp in the mesh, never the buds under a tap, no sprays or alcohol, no hard blowing → swab the case’s wells and contacts dry while you are there → still one-sided or muffled afterwards means the balance and volume-limit questions on this shelf, then a possibly failing bud.