← All questions

Phones

How do I get water out of my phone speaker?

608.How do I get water out of my phone speaker?

A phone that has just been splashed, rained on, or dropped in water often sounds as if it is talking through a wet sock. Most of the time, water is sitting in the tiny speaker grille. A short burst of sound can help push droplets out, but it is only a helper — gravity, dry air, and patience do most of the real drying.

  1. First, wipe and drain it. If the phone is plugged in, unplug it. Wipe the outside with a soft, dry cloth. Hold the phone with the speaker facing down and tap it gently against your palm so loose water can fall out. A gentle tap is enough — do not shake it hard or bang it on a counter.
  2. Try the sound trick on an iPhone. The iPhone has no built-in Water Eject button like the Apple Watch. Instead, people use a Water Eject shortcut or a trusted online tone video that plays a low, pulsing sound for a few seconds. Turn the volume up, keep the speaker facing down, and let it run once or twice. You may see tiny droplets appear at the grille. Wipe them away and repeat only a few times.
  3. On Samsung and other Android phones, the idea is the same. Search YouTube or the app store for a “water eject sound” or “speaker cleaner sound.” Play it with the speaker facing down. You do not need to pay for an app for this — a free tone video does the same job. Samsung also gives the plain advice that matters most: wipe the phone, keep water out of the speaker and port, and let it dry completely before using it.
  4. Then let dry air finish the job. Leave the phone in a dry room with the speaker facing down. A gentle room fan is fine. Sound often clears in a few hours as the last film of water evaporates. Do not use a hair dryer, heater, oven, compressed air, or anything poked into the speaker or charging port — heat and pressure can make things worse, and a pin or paper clip can damage the mesh.
  5. About rice: the old advice has changed. Putting a phone in rice was the folk remedy for years, so it is understandable if that is what you have always heard. Apple now says not to put an iPhone in rice: little grains and dust can get inside and cause more trouble, and rice does not pull water out of the inside of the phone the way people hope. Dry air is the safer version of the same patience. A sealed box with silica gel packets can help dry the air around the phone, but it is still not magic.
  6. The warning that really matters: do not charge a wet phone. If the phone shows a liquid-detection warning, believe it. Charging through a wet port can corrode the little metal pins and turn a drying problem into a repair. Wait until the phone and cable are completely dry before plugging in. If the warning keeps appearing after the phone has had a long time to dry, the cable or accessory may be the wet or damaged part.
  7. Know when waiting stops being the answer. Muffled sound while the grille is wet is common and usually clears as it dries. If the speaker is still muffled or crackly after a full day of drying, if one test sounds bad on calls, music, and videos alike, or if the water was salty, soapy, or dirty, have the phone checked. Salt and soap leave residue behind, and that is a repair-shop job, not another round of tones.
In short: unplug it, wipe it, speaker down, tap gently → a water-eject tone can push droplets out on iPhone, Samsung, and other phones → then give it dry air and time → skip the rice — Apple now advises against it — and skip heat, compressed air, and poking → never charge while the port is wet or the phone is warning you about liquid → if it is still muffled after a full day dry, or the water was salty or soapy, get it checked.