Printers
A printer that grinds, rattles, or groans while it tries to print is telling you something is stuck or straining inside. The rule for grinding is simple: do not let it keep grinding. A few seconds of grinding is a symptom; minutes of it can strip the little plastic gears that move the paper, and then the printer is done. Here is the safe order.
Press the printer's Cancel or power button to stop the job. Also cancel the job on your computer or phone so it does not start again the moment the printer wakes. Then pull the power cord out. A printer that is unplugged cannot hurt you or itself while your fingers are near the moving parts.
Open every door the printer lets you open: the paper tray, the top or front cover, and the back panel if yours has one. Shine a flashlight inside and look for:
Pull paper out slowly, with both hands spread wide on the sheet, in the direction the paper normally travels. Never yank backwards and never use tools or knives inside — torn scraps left behind cause the next jam.
Take the stack out, fan it, and reload it neatly. Slide the little plastic guides in the tray so they just touch the paper's edges — loose guides let sheets enter crooked, and crooked sheets crumple and grind. Do not overfill the tray.
A cartridge that is not fully clicked in can block the moving carrier. Lift each cartridge out and press it back in until it clicks. On a laser printer, slide the toner cartridge out and gently rock it side to side, then slide it back in firmly.
Plug the printer back in, turn it on, and print one single page (or make one copy). Quiet and normal? You found it — usually the scrap in step 2. Still grinding with clean insides, good paper, and seated cartridges? Stop using it. Continued grinding on an empty, clear printer means a worn gear or roller inside, and that is a repair-or-replace decision, not a setting. Tell whoever helps you the exact words: "It grinds even with no jam" — that sentence saves them half the diagnosis.