← All questions

Smart Home Gadgets

My robot vacuum will not go back to its charger. What can I check?

786.My robot vacuum will not go back to its charger. What can I check?

Your robot vacuum cleaned the room, then wandered, slowed, and stopped in the middle of the floor instead of going home to its charger (its dock). A vacuum that cannot find or use its dock usually has a simple cause: the dock moved, the dock's signal is blocked, or the vacuum's own eyes and charging contacts are dirty. Work through these in order.

1. Check the dock is awake and has not moved

The dock must be plugged in with its light on — a dock knocked loose from its outlet cannot call the vacuum home. And the dock needs to stay in one place: the vacuum builds a map around where the dock sits, so a dock moved to another room or even another wall confuses it completely. If you moved the dock, put the vacuum on it by hand once and let it start its next clean from there.

2. Clear the dock's landing strip

The vacuum approaches its dock in a straight line and lines itself up using a signal from the dock. Makers ask for clear space of roughly a foot and a half on each side of the dock and about four feet in front of it — no shoes, cords, chair legs, or pet bowls in that patch. A dock tucked behind furniture or in a corner often cannot be "seen" until the vacuum is nearly on top of it.

3. Clean the vacuum's eyes and the charging contacts

  • Wipe the vacuum's front window or sensor strip and the matching window on the dock with a dry cloth — dust films them over, and the vacuum then cannot see the dock's signal.
  • Find the two metal charging contacts — on the vacuum's underside or back, and on the dock. Wipe all of them with a dry cloth. Dirty contacts are why a vacuum sometimes reaches the dock, sits on it, and still never charges.
  • Empty the dustbin and check the wheels and brush for wrapped hair — a vacuum dragging a jammed wheel drives crooked and misses its approach.

4. Carry it near, then let it dock itself

Pick the vacuum up, set it down about six feet in front of the dock facing it, and press the Home or Dock button (in the app, the button may say Recharge). Watch the approach: if it lines up and settles with a chime, the earlier failure was blockage or dirt. If it circles the dock and cannot settle, the dock's signal window or the vacuum's sensor needs the wipe in step 3 once more, slowly.

5. The map may simply be stale

If the dock moved, furniture changed a lot, or the vacuum was carried to another floor and back, its saved map no longer matches the house. In the app (Roomba, Roborock, Shark, Eufy — all similar), deleting the map and letting the vacuum draw a fresh one from the dock fixes the lost-vacuum pattern for good. It relearns the house in one or two cleans.

6. When it is the battery

A vacuum that starts home and dies on the way — lights fading mid-trip — is telling you its battery is worn out, especially if the clean also ends sooner than it used to. Batteries are replaceable on most models and cost far less than a new vacuum. Tell whoever helps you the exact words: "It dies on the way back to the dock."

In short: dock plugged in, light on, and never moved → clear about four feet in front and a foot and a half each side → wipe the sensor windows and the metal charging contacts on both vacuum and dock → set it six feet in front and press Home to watch the approach → dock moved? delete the map in the app and let it redraw → dying on the way home means a worn battery.